Sink filter
pivot_valley
Trouver des similitudes avec l'IA
Profil d’impression(0)
Fichier modèle(0)
0
0
0
Publié:2023-12-16 06:06:03
2
0
000Description
Source du modèle
Avis(0)
Ce contenu a été traduit automatiquement. Afficher l'original
Surprisingly, it's quite difficult to find a good sink strainer. I was looking for something that could be placed in the drain hole
The trick to printing this filter is to use the fill mode of slicing software to create a grid. Print with three to four edge lines, without solid top and bottom layers. Then adjust the fill density and mode to obtain the desired grid effect. For me, I used a 45% triangular fill pattern. The grid is printed as a beautiful, fine single-line wall, and the printing speed is also very fast.
It is designed to fit the drainage holes of American standard kitchen sinks
Print settings
Printers:
AUDIO
Base:
None
Support:
None
Resolution:
0.2mm
Fill in:
45%
Remark:
Print with 3 or 4 edge lines, without a solid layer at the top and bottom. Select the filling mode and density to obtain the desired grid type.
Source du modèle
Lien original: Voir les détails
CC BY-SA