4/21/2020 - Updated location of ribbon cable cutout. Should fit without interference. Let me know if there are any problems.

This mounts a 7" Raspberry Pi touchscreen to any printer with 2020 extrusion.

This is a frankenstein project using designs from two other creators.

New Standalone CR10 by razorbac: https://www.thingiverse.com/thing:3025180

Raspberry Pi 7" Touchscreen Display Case by luc_e: https://www.thingiverse.com/thing:1585924

Parts Required:

-Arm for left or right side of your machine. (Goes from 2020 extrusion to adapter plate) as viewed if you're looking at the front of the printer. Thanks to razorbac.

-Adapter Plate - also thanks to razorbac

-Mounting plate - thanks me

-Enclosure for the touchscreen - thanks to luc_e

(1) M4x? Screw - Attaches arm to 2020 extrusion - I'll find the grip shortly.

(1) M4 Hammer Nut - Attaches Arm to 2020 Extrusion

(1) M3x36 - Attaches adapter plate to arm

(1) M3 Nut - Attaches adapter plate to arm

(2) M4x16 Screw - Attaches adapter plate to mounting plate

(2) M4x8 Screw - Attaches adapter plate to mounting plate

(4) M4 Nut - Attaches adapter plate to mounting plate

(4) M3x16 Screw - Goes through mounting plate, enclosure, and fastens into touchscreen.

You may have to cut out some of the enclosure to make room for the USB cable to plug into the screen. My USB cable is a little fatter than most, so it may not affect you.

Category: 3D Printer Accessories