A simple fabric tape holder. No hardware is required.

Just insert the tape inside the top part and wind it.

Place the other end of the tape in the recess given in the base.

Then press fit the top onto the base. It clicks in.

I have not tried to remove it afterwards. So make sure that you close it after the tape is set correctly.

I have uploaded to fit two different sizes of the tape.

I have printed the 17 mm model for 12 mm wide 60 inch tape.

No support or raft required.

I printed mine at 0.28 resolution.

Easy to print models.

You can customize it in Tinkercad here: https://www.tinkercad.com/things/7ZBo3neMgtn

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

0.16

Infill:

Filament: Generic TPU Black

Notes:

Category: Organization