This is an old design that  I imported from my prints on Thingiverse.

I needed a bleed block after shortening the brake hoses on my new bike.

This one works a bleed block and piston spreader.

It works on the Sram Level TLM and Ultimate brakes. But It should work for the - Apex 1

• Rival 1 - Force 1 - Red 22 - Force 22 - Rival 22 - S700 too. The one I printed was printed laying flat with support.
  And used 40% infill to give it enough strength when pulling the brake with the block in place.

Category: Sport & Outdoors