This is a remix of Misterdid's gargoyle on Thingiverse (https://www.thingiverse.com/thing:2471156), designed to snugly fit over an 18mm outside diameter pipe. It has a small hole in the bottom of the tube for a grub screw to further secure it to the pipe. Intended as a decorative way to keep wasps from nesting inside the pipe. :-)

Print Settings

Printer Brand: SeeMeCNC

Printer: Rostock MAX v2

Rafts: No

Supports: Yes

Resolution: 0.3 mm layer height, 0.6mm width

Infill: 10%

Notes:

I did a fair amount of sculpting in Meshmixer to minimize overhangs when printed horizontally. Support is still needed up to the mouth, however.

Category: Decor