Rolling paper dispenser

*edit It turns out the last few papers' ends cannot be pulled out through the slot. The box is too deep for that. An additional part (spacer.stl) is a quick fix. Slip that under a short stack of papers to raise them up.
...ticks me off when I see half-baked ideas and being guilty of it is unnerving... My thoughts are on an adjustable box but there may be other ways to do it.. Even simple things aint so simple sometimes... grrrrr...
,,,,,
This box holds a stack of around 125 rolling papers. It is sized for 70mm wide paper but the main box could be stretched or shortened lengthwise.
I have a bunch of these flimsy cardboard double-packs of papers and if one side is near empty the other stack gets all messed up, so...

The metric stl version was created by scaling but not test printed. I think it'll be ok.

The set takes 35 minutes, 14 grams ABS using Afinia defaults... 0.30 layers, medium speed and fill, with a raft.