If you just finished your reprap or repstrap or any other cool self made 3D printer, you must be very thirsty! I know that because I was too. So you can start with a beer while tweaking your printer to print really fine and cool stuff.
This will cost you a whole lot of swet too and you will be thirsty again, so you definitely need a drink! Read below how to get a good one...

1. Print a bunch of cocktail sticks (to calibrate your machine) --> use PLA plastic, this is non-toxic
2. As soon as they are fine, print some more :)
3. If you have printed enough of them, read on...

DRINK:

1. Get some rum (at least 3 Year aged.. ;) 7 works also), fresh mint, limes, cane sugar and ice cubes
2. Cut the limes in pieces, and put into glass together with some sugar.
3. Squash the limes
4. Clap your hands (with mint in between) and put the mint into glass
5. Fill glass with ice
6. Top up with rum (if you're not a really hard guy, mix with soda)
7. Stir with one of your new cocktail sticks and enjoy :)

PS: They printed fine with my 0.5mm nozzle. Perhaps they could be made more detailed with a 0.35mm nozzle...?!