I thought that a picture frame would be perfect design to try out my woodfill PLA.  I tried staining it and then I printed in bronzefill, translucent and regular PLA.   This easy print comes in two variations.  Both are sized for 3.5 x 5 inch photos.  There are two holes to facilitate hanging horizontally or vertically.  There is an inner ledge that will hold a piece of glass and the photo and/or photo and a piece of cardboard.   The first one I designed was  a tad too big for my Lulzbot mini so I trimmed it around the edges.  All of the photos display the mini version except for the grey one which is a bigger frame but thinner overall.   You don't even need to hang them on the wall as you can see I used my phone stand in one of the photos.