Cubitos from AEG is a fantastic game with poor quality dice boxes. I wanted a dice tray and storage solution that I didn't have to worry about the lid for. Also I'm obsessed with everything sitting vertical so it needed to sit nice and snug. The Thing is the insert for use with the sliding lid boxes https://www.thingiverse.com/thing:4817268

The player components lid has a built in support you can trim off with an exacto knife so you don't need any supports for it.

I wanted to keep some of room around the cards and the areas for dice roomy because it's likely a 5/6 player expansion is coming. There are some hollow spacers (print two of the side 1 for your own assembly) that are printed upside down in vase mode. If the expansion comes with more dice then you can remove the spacers and add more trays!!!

As a suggestion for stability you can print a vase mode at double your typical line width. (.4mm nozzle? then .8mm for vase mode).

No

No

200

20