Aztec Temple for your succulent? Yes, another succulent planter for your desk or home. This one has the over water drain in the basement that goes under the stairs. If you see water there, you have watered too much. The bottom vents allow the soil to breathe.

The original here was printed using 3D Mars Wood PLA at a resolution of 0.2 and 20% infill. There is no need to use supports when printing. All the over hangs are arched and should print just fine without support.

3D Mars Wood PLA: http://amzn.to/2C4Tl2S

My Printer: http://amzn.to/2BBYP4t

Print instructions

Category: Decor Print Settings

Printer: Maker Select

Rafts: No

Supports: No

Resolution: 0.2

Infill: 20%

Notes:

All the over hangs are arched and will print without supports.