This is a replacement for the cap of the Logitech Shifter, because I use the shifter as a headset stand.

In the picture, the printed cap shown is the one I’ve been using for about 5 months, so it’s a bit damaged from my headset.

Assembly / Installation

1. Remove the screw from the knob and take off the original black plastic cap.
2. Place the base in, making sure the cutout in the middle is facing the bottom side.
3. Screw everything back together.
4. Push the cap in (it’s a very tight fit; if you prefer a looser fit, use the “Cap_Loose” file).