The Raspberry Pi Zero is a new milestone in low cost computing. We here at Make: wanted to ensure that you have a safe way to house and transport your new pocket power house so we designed this easy to build case. No screws or extra parts required!

Designed by Make's Digital Fabrication Editor, Matt Stultz.

Read more at Makezine

No

No

.2mm

This was designed to be printed at .2mm but should be good at finer resolutions.

If you wish to access the GPIO pins, the thin panels in the base or lid can be cut away using a razor.

This case was designed in OnShape and is a public model that can be edited at: http://bit.ly/1XOjrXN