-There is 2 base models, one is short and you should print the with good adhesion, I prefer a small brim around the “pointy” end. The other has a “spear” to stick into the ground, for better stability, that one should be printed with the spear upwards, you might need some support inside the base for this one, depending on your bridge settings, if you aint sure, add some support, to be sure. The base only has one pattern as its supose to be nearly completly submerged in the ground.

-There are 5 patterns for the actual pole, Hexagon, Circle, Leafy, Squares and Hearts, mix and match to your mood, or go full one pattern. Non of the patterns need support if you dont change print orientation from the files. Everything snaps/Slides together, to form a never-ending pole, to add strenght you can glue them together (not needed with my settings) so proceed how you see fit. :)

-Havent had the time to print EVERY pattern yet, so please share your makes <3