Four versions of 2” hydroponic net pots, designed to work well when printed using standard settings on a Replicator 2.

My initial attempt was difficult to print, which is why I created versions with built-in support. The support generated by MakerWare was in a messy state.

These net pots should naturally have walls that are two layers thick when printed on a Replicator 2 with standard settings. I’ve included the SCAD file, so it should be easy to make adjustments if your printer has a different resolution.

For the two models equipped with a base support, use a pair of pliers to squeeze the support near the base of the pot, and it should snap right off.