I salvaged some adjustable leveling feet which didn't have rubber pads on them, so I modeled them.  The adjustable feet I have are not labeled/stamped in any way.  Mine happen to be 2 3/8" diameter and 2.6mm thick.  I figured it is unlikely others will want this exact dimensioned model, so I made this fully parametric.

To customize:

• as long as you can load and export a model in Fusion, you can adjust this model via MODIFY > Change Parameters.

• you can also Customize this on MakerWorld.

Note:

• You must print this in TPU, as this model is designed to flex around the foot.

• No supports are needed.

I printed with Varioshore TPU (92A) and used these settings: https://forum.bambulab.com/t/my-varioshore-tpu-settings-on-the-h2d/172752