Project: nutcraker.hfp

I own the license to the image.

I glued 2 button magnets onto the back.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 120x120mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.3mm

Filaments Used:
PLA BambuLab Black Transmission Distance: 0.3
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA Geeetech Grey Transmission Distance: 1
PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 4 unique filaments

Swap Instructions:
Start with Black
At layer #8 (0.72mm) swap to Blue Gray
At layer #16 (1.36mm) swap to Grey
At layer #18 (1.52mm) swap to Jade White for the rest.