A set of simple hexagonal coasters, with a matching stand, designed to look clean and modern on any table or desk. Each coaster has a recessed pattern that helps collect condensation water, keeping the table dry and clean.

When not in use, the stand can neatly stack up to 6 coasters, making the set both practical and beautiful.

This design has been optimized to allow for easy 3D printing without the need for supports, and it works well with common materials such as PLA or PETG.

Recommended print settings:

• Floor height: 0.2 mm
• Filling: 15-20%
• Wall/perimeter: 4-5
• External wall speed: It is recommended to set it at 30-40mm/s to achieve the best surface finish
• Support: Not needed
• Materials: PLA or PETG

Thank you for your feedback and suggestions!