Hello everyone! I made this for my daughter. 

There is a version with a small drawer in the belly and a version where you can glue the belly in.

Make sure when you put the nostrils and the eyes in that you pay attention to the outside end of the piece. The outside end of the pieces are angled to align with the angle of the model.  It is very hard/impossible sometimes to remove the eyes or nostrils even without glue. So make your you double check.

In all of my tests, the eyes, nostrils, and nose held in very well without glue. The horns and ears slide in tight but are still removeable if no glue is used. Lastly, the belly is easy to remove since it can be used as a draw if you print that version. So if you want to use the version without a drawer, make sure to glue the belly in.

I recommend using adaptive layer height on the mouth, nose, nostrils, and eyes. supports needed in hole for bridge of nose.

If using a light color that is semi translucent, increase to 3 walls!

Attached are the .STEP files and the .F3D files in case you want to change something about the model.