I have a bunch of pictures of the family in all shapes and sizes and I wanted them all on the wall. But I didn't like having to buy or make a frame for each. I wanted a system where I could add as many i would like in all sizes. 
 

I tried making some for the honeycomb modules, but there was so much waste and it didn't fit either. 

This design is simple elegant and you can quickly make very long strips, meaning that you can make a picture wall in no time. 

2 layers with alternating direction of flaps. 

24.8 cm long 

2 cm wide

longer flaps in both ends to snap into each other and connect without the need of tape, glue or pins. 

Top strip needs to be fastened to the wall of course, I added a hole for a pin, otherwise there should be plenty of surface for double sided tape. 

feedback and remix is welcome.