This is a mount for a raspberry pi camera designed to be stuck to a vertical surface with double sided tape or any other form of glue. The camera is fixed to part number 1 via some M2 or M2.2 metric screws, that screw directly into the 3d printed plastic(Make shure not to tighten them too much). The parts are connected via M4 bolts and nuts(If they don't fit try boring out the hole with a 4mm drillbit). I've printed this in PETG but every filament should work.

Additional required parts:

2 x M4 screw

2 x M4 nut

2 x M2/M2.2 screws

Category: 3D Printer Accessories