Yet Another X-axis holer for the Velleman K8200/3Drag printer.

I have been looking for a stable holder with the end stop mounted on it, as i dont Think that there is a Point in moving the screw.

This is designed so that you can cut of the metal bit, making it more precis and less vibrations from it.

I have also raised the stepper motor a bit compared to the original to commodate GT2 belts with 20 or 16 teeth pullys.

I have designed it so that it should be printed with the bit towards the alu bit downwards.

I printed it and after adding it to the printer it got notisable more acurate.

27.06.2018: Added .f3d and .step files

17.07.2018: Adjusted it a Little and now it fits and is much more studier than anything else i have looked and tried.

24.07.2018: Made some major Changes that means that it can print with only support from the build plate.

It's also more stable as the whole motor is supported by the plate and the hex screw is moved so that you can adjust it when mounted.

I have tested it on my own printer and it sits rock solid.

16.09.2018 Redesign of the holder to lower it 5mm.

That is to get it to fit with the upgrade https://www.thingiverse.com/thing:829491

This should sit as solid as the other one.

I hope you like it :-)

Print Settings

Printer:

K8200

Supports:

Resolution:

0.2

Infill:

Notes:

You can print this as you like, but wold be best with thick walls and much infill.

Category: 3D Printer Parts