Summary

A wall-mountable headphone holder, originally designed for a specific setup where an existing screw hole was lower than ideal.

Instead of drilling a new hole, this design lets you reuse a lower mounting point and still position the headphone hook higher—ideal if you’re dealing with leftover holes from previous mounts.

While it was designed for a personal case, it should work well in general, especially in setups where you want to hang headphones neatly without drilling new holes.

✅ Minimalist and functional design
✅ Can be printed with or without supports, depending on your printer setup
✅ Designed for wall mounting—screw mount recommended
✅ Fits most over-ear headphones

🖨️ Print settings (suggested):

Layer height: 0.2 mm or lower

Infill: 20%

Supports: Recommended, but can potentially be skipped with good printer calibration and a low layer height

💡 Works great if you want a clean look without damaging the wall further.
Let me know if you remix it for other wall situations or add cable hooks!