Summary

I looked online but decided to quickly design this case + stand for my new Riden 6018 power supply head unit. I did not want to buy a specialised case because i need this head-unit to be detachable from the AC supply and plugged into Li-Ion battery packs when needed.

The case fits 6018 snugly but possibly will fit most 6006/6012 units as well. I added some "ears" at the top so that you can wrap your temperature probe when it is not in use.

Printed using standard PLA+ set at 210 deg C (extruder) and 80 deg C bed. Print speed at 70. There is no need to print with supports (i avoid supports as they somtimes cause print blunders if they get bumped off on the print bed).

You can print the Stand seperately if needed and just glue to the bottom of the Case. This will tilt the case at upward angle if you need it.

The Fusion 360 files are included if you wish to modify the design further.

Enjoy.