This is a conversion from Bowden to Direct Drive.
You will need to drill 2 holes in the original front X carriage.
bolt the adapter to the front side. Drill the 2 holes, then install mount on the backside of X carriage.the weight of stepper motor should also sit on top of the back carriage for added support.

for the ptfe tube: cut a piece long enough to bottom out in hot end and lock in place with spacer retainer clip. then place guide tube on top of hot end and cut ptfe tube flush or just a little longer to ad tension.

mow ready to assemble

there is 2 types for the guide tube. print as 1 pc or 3pc and glue together

DBOT

No

Yes

.2 OR .3

I USED 100%