I noticed there is just not enough variants of Donkey Kong barrels on Thingiverse ;-)

So I designed this Tropical Freeze inspired barrel which fits three logos. Currently available logos: DK, DX and an arrow. Might upload more as I design them.

Instructions:

• Print the barrel as-is
• DK and DX logos can be printed in two colours by enabling Filament Change in Cura at the correct height
• Attach the logos using super glue or wood glue
• Print two of each ring. They should simply snap in but may also be glued in place.

There is also a single logo and a dual logo variant of the barrel available.