Got a Raspberry Pi Touch Display? Tired of it flopping around on the desk? Print these two little legs for it and let it stand proudly.

(Updated 12/29/2020 - The previous version wasn't tall enough to allow most USB power cables to be plugged in, so I embiggened it.)

Prusa

I3 MK3S

No

No

.20

20%

Print it bottom-side down (the way it's shown in the preview) and you shouldn't need any supports.

I used four M3 (I think?) screws to attach the legs to the screen. Don't use screws that are too long, or tighten them too much - you might damage the screen. A hole is provided through the bottom side to let you tighten that screw more easily.