Hide the entangled wires and keep them away from the ground to avoid clutter and disorganization.

I rarely remove the console from its base, as this helps minimize the number of hanging components and maintain an overall neat and organized look...

You can use any settings when printing. This time, I chose the coarsest printing parameters with a printing speed of 100 mm/s, and the whole process only took a little over an hour.

However, there's a small problem: it's really hard to screw the Allen wrench into the screw hole. The Allen wrench that came with the printer is not long enough, so I used my own longer screwdriver with a diameter of 2.5 mm to complete the job.

Simply loosen the console bracket by a few millimeters, then place the component to be installed in between. You can clearly see this process in the images I've uploaded. Finally, just tighten the screws again.

https://youtu.be/Xq1sikR6O4c