Finally made a customisable version of the modular y carriage. My head getting more confused and dizzy when I make this and incorporating more modules inside especially the lm8uu mounts.

The beam's 2 screw holes are 10mm apart instead of the previous versions which was around 8-9mm apart from the center.

It is assumed that if you're going to use this customisable modular y carriage means you know the width of your 8mm smooth rod for your machine.

If you want to help me simplify this it would be greatly appreciated through the comment, I tried my best for this one.

I know there are tons of variables out there, but the most important ones are

• dimX,dimY - based on the size of your heatbed
• mountingOffsets - the offsets for screw mounting holes
• tolerance - clearance to match your printer's accuracy
• preview - preview or printable parts 0:1
• view - the parts you want to be rendered
• posX,posY - lm8uu mount attached to the corner parts
• bearingz - lm8uu mounting heights if you're using the bearing on the beam
• lm_beam - 0:1, if you want the lm8uu mounted on the beam or corner
• modular_beam - If you want to have a single beam or modular
• beam_corner - how much offset you want the beam to be from the edge, useful with lm_beam=1
• Xbase, Ybase - These are the base position for the mounting at the outer edge of the corner module