A revised version of the Bruh Automation and TrueOverFlow multi-sensor case that includes:

• Space for BH1750 light sensor
• Higher stand-offs for NodeMCU Amica board
• Pinch-clip at bottom of case to hold it together more effectively

Parts list to construct your own sensor:

• BH1750 light sensor
• AM312 PIR sensor
• NodeMCU v1 (Amica, NOT Lolin board)
• Red LED (used to show PIR triggered)
• 470 ohm resistor
• DHT22 Temperature/ Humidity Sensor
• Header wires (I'd suggest 10cm wires to get a nice "fit" inside the case!)
• USB Power Supply
• Large Fresnel lens

Use Tasmota as the firmware/ software. This works reliably with the attached GPIO configuration.