This is a case for the Morse Code Tutor (MCT) conceived by W8TEE (Jack). This case fits the board developed by KI4PSR (Dave) that supports this software as well as the alternative implementation by W8BH (Bruce). Please see the SoftwareControlledhamRadio on groups.io for more details.

This case was derived from the one originally made available by KI4PSR. It has been enhanced for the larger LCD as well as moving the speaker to the top of the case. There are knockouts for power on either side of the rear and an additional kockoff on the right for a toggle switch.

This one fits a 3.2 inch lcd. There is an alternative case available for a 2.2 inch lcd that is smaller.

The speaker holes are 60mm on centers for a 77mm (3 inch) speaker. Just be aware that on this case the height from the bottom of the speaker to the top of the voltage buck could be a constraint.

This thing includes:

• Base
• Top
• Legs
• Bevel

I used the fluted knobs that I found here:

https://www.thingiverse.com/thing:3464847

All the hardware is M3 and appropriate holes are threaded. But as always, would recommend running a tap through the holes to make your assembly easier.

Creality

Ender 3

No

No

I did not use supports in printing. However, you might want to create a support for the middle of the LCD cutout as it is a long bridge and you can see a slight dip.