I made this to allow the mess of wires from my Commodore 64 to pass underneath the console to reclaim some desk space. This would also be useful if you have a controller adapter for the 7800 that sticks down too far and bumps into your table.

Print the top and bottom pieces as-is. Print four legs scaled at 99%. Use gentle force to push the whole mess together. Then, use four medium-sized zip ties to attach the stand to the bottom of the console using its built-in wire guides (see images). Make sure to utilize tension with each zip tie equally or it won't be centered. The result is a pretty sturdy stand that allows you to gently put in a cartridge without everything falling over or breaking, though I would still recommend holding onto the console when inserting a cart.

Creality

Ender 3 Pro

No

No

0.2

15

Used a raft to print four legs at the same time without anything falling over. Be sure to scale them to 99% or they won't fit in the top and bottom holes.