This is a modular pegboard designed so you can build out your own full-sized pegboard. The protrusions on the back are designed to provide some separation between the board and the wall so pins can fit through.

Warning: the protrusions on the back have a small footprint, which means that with enough weight they could possibly punch a hole in something like drywall. I have not thoroughly tested this aspect of the design, so I recommend you don't use this pegboard on any wall you care about.

Note: this is an early version, so there are some minor problems and TODOs that I will not have time to address anytime soon. Feel free to build on and around this design as much as you like.

Personally, these are my TODOs for this board:

• Make the connectors lockable (right now they slide in and out of place.)
• Make a bar for the outer edge of the pegboard for easier weight distribution and mounting.
• Improve the wall separators so they are less likely to punch holes in walls.