I decided to make these alignment sticks to practice my golf swing instead of buying them.

They are really easy to print and require a very small amount of filament.

Print settings:

Quality: 0.16mm

Wall: 6

Infill: 15%

Support: Yes, for the end cap and connector if you print them upright.

You will need (for each stick):

• 4x Rods
• 3x Connectors
• 2x End caps
• Elastic cord (I used elastic sewing band, 3/8" width)
• Super glue

Instructions to make the sticks:

1. Glue one connector to one end of a rod. Repeat this step 3 times.
2. Make a large knot at one end of the elastic cord and thread it through all the rods.
3. Make sure there is a significant amount of tension in the cord (it should be similar to the tension of a tent pole) before tying the knot at the other end.
4. Finish by gluing one end cap on each end of the rods.