Pivoting under-mounted headset hook

This headset hook mounts under your desk and folds away when not in use, for a clean look and zero interference!

Unlike many clamp-style solutions, this headset hook screws into your desk from its underside, so that it does not take up any space on your desktop. It also pivots 90 degrees, so that it can be folded away when not in use, avoiding bumping into it and keeping your desk looking clean.

Note: works best with solid desk tops from any wood-like material (plywood, osb, particle board, butcher block etc.) May not work with hollow, cardboard honeycomb style desks.

Features:

• Prints with no supports with any printer and filament.
• Easy to print with forgiving clearances that require no sanding or post-print processing
• Only hardware required is 2 wood screws
• Included is an STL for a minimal drilling guide to help you pre-drill holes correctly
• Supports heavy headsets with no issue

Instructions:

1. Print using your preferred settings & materials
2. Use the drilling guide to mark and pre-drill 2 holes in the underside of your desk. The drilling guide indicates hole spacing in relation to each other, and the small lip on it helps you position the holes at the right depth from the desk's front
3. Assemble the arm onto the bracket (see photos)
4. Screw into your pre-drilled holes with regular wood screws - a short one for the rear, and a longer one for the pivot point.