A whiteboard marker tray with honeycomb design. Whiteboard markers are best kept horizontally hence I needed something simple that could stick to whiteboard's bezels using clear double-sided tape and can hold 5-6 markers.

I've never used Fusion 360 before, so this was my first real attempt on using it and making something out of it.

Creality

Ender 3

Doesn't Matter

Doesn't Matter

0.2mm

N/A

Since this print took about 4hr 30min on 0.2mm layer height, the quality is just okay. If you print at 0.06mm layer height, then it would take around 14 hours but you'd get much better print, specially in the curved area.