After knocking over my Ring Base Station a few too many times, I did a quick remix of my own ADT Pulse Hub Stand to mount the Base Station to.

I wasn't looking for perfection when making this, just something quick to mount it to.

I printed it laying down (25% infill) , but that does use a lot of filament with the supports.

I would suggest when mounting to the back with screws, to make sure the bottom of the Ring alarm's base is resting on the bottom of the base instead of hanging from it. In the pic you will see I put tape over the back of the screws, I needed to remove them to grind them down.

Hope this will help anyone until a better design comes out.

Thanks!