This model allows you to hang your filament on a clothes hanger pole (i think that's what it's called) or really any tube under 35mm in diameter.

You need to print two of the Hanger models, and one connector. The little bits on the ends of the connector slide into the holes at the bottom of the hanger, then twist it to lock it in place.

Layer height: <0.30mm

Supports: Only on Connector

Nozzle: 0.40mm

Weight: 27.77g

• Hanger: 11.33g x2
• Connector: 5.11g

Material: PLA

Print Time: 2h 8min

• Hanger: 42min x2
• Connector: 44min