A monkey face on an owl was requested, it feels like the kind of thing which could be cute.  This feels borderline.  Perhaps I should stick with fish.  I'm done for the night :)

v2: I was told I needed to make it more owl-like.  It now has some horned owl stuff.  Also cleaned up pose / musculature a little because I didn't know what would make it more owl-like.   

Note: Still targeting printability, but haven't gone through any iterations cleaning up overhangs so details like the underside of the hanging arm likely still would benefit substantially from supports.

v2.1: Cleaned up the under-arm for printing.  Tis a delightful, short, impressive display of no-support FDM printing (if your bed adhesion can take it (eg: Bambu X1C cool plate PLA w/ fresh glue-stick)).