This is the unique keychain. To make this You will have to check on which layer the bridges will be printed and than place chip inside frame during printing. Better to slow the printer down to about 30-50% (i was printing with 60mm speed) to make this operation easier.

Remember to clean the chip before printing and place it on heated table (if printing on heated

table). This will not shock-shrink the print.

There is also a version for a CPU with pins.

Good Luck ;-)

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

0,2

Infill:

Filament: Compositum ABS AT Black

Category: Keychains