#What this remix does

It gives you holes in the parts with the desired dimensions of your pipe and also makes sure a minimum wall strength is attained.

also you can generate a new center piece to fit your pipe dimensions

#What this remix doesen't do

the height between the magnet mount and the bottom plate will surely change with pipe dimensions.

no more fancy bevels..

#how this works

you need to download the original parts and place them in the path \ZenXY_-_23.5mm\files\ relative to the .scad file. Then change the desired dimensions and have the parts generated. I would propose not doing all at once

currently the center pieces are not valid 2-manifolds and might need repair, slice with care

I printed the center part sucessfully for 20mm PVC pipe

I also made some printable bolts and Hex nuts for the connections

please create a make if you did this and let us know what dimensions your pipe had

Thanks allted for the Idea and the easy to customize pieces.

Old description

Since the original project was only useable with 23.5 OD pipe I made his customizeable version where you can configure the pipe dimension. The changes are only related to the cutouts for the pipe. The position of the bearings remains unchanged, especially the center might need some additional adjustment to run smooth on the new pipe dimension. If using bigger pipe 25mm ect. pay closer attention to the clearrances between the parts Use with care

Print Settings

Printer:

Anet A8

Rafts:

Supports:

No

Resolution:

Infill:

10%

Notes:

Post-Printing =============

I ran a drill bit trough the holes to get better fits for the screws

Category: Art Tools