Update 24/7-18 Needed better cooling and lower mass on the X-axis. Decided to make nozzles that press fit into the opening of the fan, this works a lot better than the previous design. Not as clean looking but that might be revised in the future.

---

I wanted a hotend that utilized my 3510 5V fans i had laying around instead of the the big and noisy blower that the hypercube uses. And the same time hides away the wires as much as possible.

I remixed the Carriage to be wider and removed the endstops as im using the duets ability to sensorless home.

This is for the Zesty Tech Nimble, and the Piezo sensor

The fans for the fanducts are bought from Ebay. Delta BFB03505HA 35x35x10mm 35mm 3510 5V 0.17A DC Brushless Blower Fan

The 40mm is a noctua fan.

The Step file has been added.

Category: 3D Printer Accessories