After upgrading the SSD in my machine, I had the smaller one laying around collecting dust. I had a simple USB SATA interface adapter that came with the SSD to clone the old drive to the new that worked perfectly for an external drive, I just did not have an enclosure to hold it all in, until now. This one was made with clear ABS and uses M2.5 hardware to hold it all together. The screws are 6mm in length but the corners should have been shorter, I think 4mm would do since they are not structural. There is minor clean up work on the screw holes and the nut captives need to be cleaned up with a small file. I have included the FreeCAD files so you can edit all you want. The SSD cutout was made with a font located : http://www.fontpalace.com/font-details/7th+Service+Condensed/