A friend requested this deck box, but themed to the Warhammer 40k commander decks - simple, but effective!

I printed two of each with the logo against the bed - I used supports and removed them afterwards, but depending on your tolerance you may be able to just bridge the logos, and/or may like it with the supports still in place (if I hadn't removed it from one initially, I would have probably left it on all).

Magnets information from original post:
8x 5x3mm neodymium magnets.
Link for magnets: https://www.amazon.com/5x3mm-Personalized-Multi-Use-Whiteboard-Refrigerators/dp/B078HTF489/

Check orientation of magnets PRIOR to gluing in.
Take 8x magnets and make four pair.
Then put a dot of cyanoacrylate in each of the 8 corner holes, and place the magnets inside. Then press against a flat surface and wait for it to cure.
PLEASE NOTE: The hole is a 6mm hole, this gives a .5mm gap all around the magnet for CA glue so you can 'pot' it inside the hole to ensure it will not come loose.

Elegoo Neptune 3

No

No

0.4

20%