This is my first ever attempt at 3D modelling and printing. As much as I love the Odin speedloader, one thing I didn't like is the handle coming off so easily after a while. So I designed a replacement handle with some minor improvements in order to prevent this from happening. Made it in 2022 and has never had any problems with it coming loose ever since.

Hardware required:

1x M3 lock nut

1x M3x30 countersunk screw

1x M3 washer or a gearbox shim

Instructions:

First, you push in the lock nut flat end down into the hex shaped hole. It may be a tight fit so you might have to use a mallet to pound it in. Then you put the screw through the odin speedloader. From there, place the washer on to the screw and then you screw in the handle skinny side first. Make sure to use a set of pliers or vice grips to carefully screw in the handle all the way till it catches the nut.