This is the same as Long Leg but doesn't have a tapped hole on the bottom. It's really just for aesthetics to not have a bore. This leg is 94mm tall with another 10mm for the threads.

Each leg as 6 slots for attachments. This leg has no threads on the top to screw down other parts. This leg is 94mm tall.

Please note that this shouldn't be used as the top piece as a short leg no threads is preferred because a leg needs to be screwed down to fasten the attachments (if that doesn't make sense, don't worry. It's obvious once it's printed). 

Each leg as 6 slots for attachments. This leg has no threads on the top to screw down other parts. This part is 64mm tall and another 10mm for the threads.

This is the same as Medium Leg but doesn't have a tapped hole on the bottom. It's really just for aesthetics to not have a bore. This part is 64mm tall and another 10mm for the threads.

Please note that this shouldn't be used as the top piece and a short leg no threads is preferred because a leg needs to be screwed down to fasten the attachments (if that doesn't make sense, don't worry. It's obvious once it's printed). 

This is the same as Medium Leg but doesn't have a threads on the top. It's really just for aesthetics to not have threads. This part is 64mm tall.

Please note that this shouldn't be used as the top piece and a short leg no threads is preferred because a leg needs to be screwed down to fasten the attachments (if that doesn't make sense, don't worry. It's obvious once it's printed). 

This is the shortest of the legs and is usually used at the tops and bottoms after getting a desired height. This part is 15mm tall with another 10mm for the threads.

This is the same as Short Leg but doesn't have a tapped hole on the bottom. It's really just for aesthetics to not have a bore. This part is 15mm tall with another 10mm for the threads.

Please note that this shouldn't be used as the top piece as a short leg no threads is preferred because a leg needs to be screwed down to fasten the attachments (if that doesn't make sense, don't worry. It's obvious once it's printed). 

This is the same as Short Leg but doesn't have a tapped hole on the bottom. It's really just for aesthetics to not have a bore. This part is 15mm tall.

Please note that this shouldn't be used as the top piece as a short leg no threads is preferred because a leg needs to be screwed down to fasten the attachments (if that doesn't make sense, don't worry. It's obvious once it's printed). 

This Pergola attachment hangs off of the legs. I've tested it to hold just about 5 pounds of weight comfortably with PLA. This part is takes up 2 of the 6 slots for attachments at each level spanning 60degrees from center

This Pergola attachment hangs off of the legs. I've tested it to hold just about 5 pounds of weight comfortably with PLA. This part is takes up 3 of the 6 slots for attachments at each level spanning 120degrees from center

This Lattice Attachment hangs off of the legs. This is specifically designed for things like vines to hang off or grow throughout. The lattice's height is equal to just under the length of a long leg a long leg is suggested to be used with it. 

This attachment is for supporting the base within the soil to hold the trellis upright. Print 6x for the best support, but really only 3 are needed.