I printed this magnetic catch because the plastic parts on my window covers started breaking apart.

The measurements of this part are 50x15x5mm and it fits a 30x10x2mm flat magnet very snugly. It may be needed to widen the gap with a small knife, however I didn't need to make any adjustments after printing.

The screwholes fit a 7mm head and are a tight fit for a 3mm plastic/wooden screw.
The distance between the two holes ist approximately 40mm.

Print settings:

• 0.2mm layer height
• 20% infill is enough
• print without rafts or supports
• PLA is most likely strong enough, as the part it's replacing doesn't see much stress