I took a look at the design and decided that I wanted to make it to where it could be printed with no supports, use the original hot-end mounting screws, as well as support direct drive extruders (for my case, the OMG DM1) I also decided to chop off just a bit of the vents to allow for less restricted airflow, which has proven to reduce noise, and increase cooling performance!

I would have never been able to make this original design, and I thank the original creator immensely for allowing me to edit and improve upon the design as I saw fit!

This new design should only require 2 fans to be purchased, and not require any other screws

Print Settings

Printer:

Elegoo Neptune 2

Rafts: 

Doesn't Matter

Supports:

Doesn't Matter

Resolution: 

.2mm

Infill:

15% cubic

Filament:

Overture PLA 

Matte Black

Notes:

This should not need supports, but if you are worried about lack of cooling or the bridges failing, the center bridge should be supported

Category: 3D Printer Parts