Note: This model is currently quick work and untested.
Will updated once it has been tested.

• Quick LED lamp for the incoming 2011 Hurricane Irene...
• Insert LED's, Solder, GorillaPod it somewhere, And read through the hurricane.
• Two attachment pads that -should be- compatible with GorillaPod tripods.
• Back plate that shields electronics is held on by cantilever friction.

Setup:

Insert 20 LEDs from lampshade side, bending each of the legs outwards to hold into the holes

Leave enough gap to allow LEDs to be bent and re-pointed compensate for narrow beams.

Soldering depends on your power source...

3 volts:
Each of the 4 rows should have 5 LEDs in parallel. connect the 4 rows in parallel.
Make sure to bend the LED legs the right way to make your life easier by aligning all.

12 Volts:
5 parallel rows of 4 LEDs in series

My Current plan is to implement a pulse-width-modulation circuit using a micro-controller, using a voltage-control feedback, basically implementing switching.

However, two 1.5v Alkaline batteries may accomplish the task as well, but will get dimmer with time (voltage falls off as battery is depleted.)