Couldn't find a wall mount for VHS that didn't cover the art on the sides of the box so I made one. Mounts to the wall with two 1.65mm finishing nails. Perfect for displaying your VHS tapes as wall art. Made it for displaying my GI VHS (a little reminder of the GI Joe remix Youtube videos). Prints fine with no supports at 10% infill in PLA+. Could also easily be mounted with command strips. Uses minimal filament (15g). Be careful hammering in the nails, it is still only plastic. Tape over the tops of the nails once they're in the wall since they may scratch the back of the VHS (I added a slight inset but it's only 1mm). I found you can get away with just using one nail if there’s enough friction.