After using the version 1 a while I realized it sucked in some areas. Firstly, my hands aren't as steady as they used to be and when I wanted to engrave on both sides of a tee, it was a real pain turning all the tees.

So, I made one that you stick the tees in and then can just flip it over if you want to do both sides.

I made the holes very tight for the tees I am using as I found if there was a lot of play, the tees would get out of alignment very easily.

I made it the way I did so that I could engrave the letters in the right direction on the tee and not have to have the words upside down in Lightburn.

I have included my Lightburn template.  I place the rig against one of my right-angled jigs so I can use absolute coordinates to speed things up.

Only used this a couple of times so far, so haven't uncovered version 2 shortcomings yet.

:-)